13.
Press the (UP) or (DOWN) key repeatedly to select the desired character (be
sure to use the correct capital and lower-case letters), then press the ENTER key
once to shift the flashing cursor to the next character position.
14.
Repeat step 12 to finish entering the password.
15.
Press the MENU key repeatedly to leave the menu system and set the password.
5.3.3 Clearing the Password
Clearing (removing) the current password prevents unauthorized personnel from ac-
cessing the
Private
menu and accidentally disabling the TLS.
The current pass-
word should always be removed after the service technician finishes using
the Private menu.
Three things happen when a user clears the password:
•
Private
disappears from the
Top Menu
.
•
Access
reappears in the
Private
menu.
•
CLEAR ACCESS
(shown in Section 5.3.3) disappears from the
Private
menu.
1.
Press the MENU key to open the
Top Menu
.
2.
Use the (DOWN) key to move the pointer to
Private
.
3.
Press the ENTER key to enter the
Private
menu.
•••••••••••••Private
•Blower
•Calibration Left
•Calibration Right
CALIBRATE
•Carousel
CLEAR ACCESS
•Configuration
•Display A/D
•Display Locations
•Display Positions
•Display Sensors
•DriveBay
•Executive
RESET SCSI BUS
4.
Use the (DOWN) key to move the pointer to
CLEAR ACCESS
.
5.
Press the ENTER key to execute the
CLEAR ACCESS
command.
6.
Press the MENU key twice to exit the menu system.
The password is now cleared. Notice that
Private
is no longer visible in the
Top Menu
.
501380 Rev. B
The Private Menu
5-7
