•
When the optical sensors detect a fully-inserted tape cartridge, the I/O
port slot retracts, closing the I/O port door.
•
If the tape cartridge is not fully inserted, the door will remain open.
•
If no tape is inserted, the I/O port slot retracts one or two minutes af-
ter the I/O port is summoned.
Use the
Configuration\Advanced\Changer\I/O Port CALL Key
menu item to select either the one or two minute delay time.
3.
The host software then determines where the tape cartridge should be stored.
The storage location can also be manually determined using the menu system
provided the menu system has not been locked by the system administrator.
*000019A*
0
0 1 9
0
0
Label Side
NOTE:
Attach the barcode label to the cartridge
with the numbers at the top as shown.
The AIT-1 tape cartridge is write protected when the
Enable/Protect Tab is open.
The AIT-2 and AIT-3 tape cartridges are write
protected when the Enable/Protect Tab is up
towards the label side of the cartridge.
Write Enabled/Protect Tab
Shown with Write Enabled.
AIT-1 Tape Cartridge
AIT-2 & 3 Tape Cartridge
CALL
Figure 3-3 Inserting a Tape Cartridge into the I/O Port
3.1.6.2
Parking the Handler
While the operating display is visible (Figure 3-1), press and hold down the (Daisy)
key to view the (Daisy) key menu (Figure 3-3), press the (UP) or (DOWN) key
to execute the
PARK HIGH
or
PARK LOW
command, then release both keys.
3-4
The Menu System
501380 Rev. B
