4
Step 5: Attach upper front panel [C] to the unit as shown in Fig. E with 6 KD screws. See Fig. E.
Fig. E
BACk
Step 6: Attach top panel [A] on top with 3 KD screws. See Fig. F
Fig. F
BACk
Step 7: Tighten all KD screws.
I
NStAllAtiON OF FOAM tAPE ON YOUr
FirEPlAcE iNSErt
Step 8: Foam tape (Z1) has been provided to protect your fireplace mantel. Remove the
backing paper from the foam tape.
Step 9: Attached the foam tape to the left and right side flanges of the insert, as shown
in Fig. G. The foam tape shall be spaced about 10 – 15 mm (0.4 – 0.6 in) from
the front edge of the insert.
Fig. G
Step 10: make sure that the foam tape is completely covering both, the side flanges, as
shown in Fig. H.
Fig. H
BACk
FirEPlAcE iNSErt iNStAllAtiON:
The fireplace insert can be installed after the mantel has been fully assembled.
wARNING: MAkE SURE THE FIREPlACE INSERT CONTROlS ARE IN THE OFF
POSITION AND THE UNIT IS NOT PlUGGED IN.
Step 1: Attach 2 Large “L” brackets [Q] to each side of the fireplace insert with washers [S] and
secured with small screws [T] and nuts [R]. See Fig. I.
Fig. i
BACk