4
Fig. E
Step 6: Attach Top panel [A] to the unit as shown in Fig. F with 4
KD screws. See fig. F
Fig. F
Step 7: Tighten all KD screws.
FIREPLACE INSERT INSTALLATION:
The fireplace insert can be installed after the mantel has been fully
assembled.
WARNING: Make sure the fireplace insert controls are in the
OFF position and the unit is NOT plugged in.
Step 1: Attach 2 large ‘L’ brackets [Q] to each sides of fireplace
insert with washers [S], and fixed by small screws [T] and nuts [R].
See Fig G.
Fig. G
Step 2: Carefully place the INSERT in the unit opening. The front
of INSERT should be flush with the front of the mantel. Carefully
lift the INSERT into the mantel until the top stopper is against the
mantel.
Step 3: Attach fireplace insert to the unit as shown in Fig. H with 6
medium KD screws [U]. (4 screws at the top side of insert and 2
screws at Big L shape brackets. See Fig H.
Fig. H
Step 4: Move assembled unit to desired location. Unit should not be
positioned in area exposed to direct sunlight.
WALL ANCHOR SAFETY CABLE
The use of WALL ANCHOR SAFETY CABLE is highly recommended
in order to reduce the risk of the fireplace being tipped over acci-
dentally. WARNING: This CABLE may reduce possible risk of injury if
the fireplace is improperly handled, but is not a substitute for proper
adult supervision. Children should not be left unattended near any
heater.
1. Drill a 5/16 in (8 mm) hole in the wall. Insert the PLASTIC
WALL ANCHOR into the hole and gently tap until the flange on
the anchor is against the wall surface.