8
O P E R A T I O N
After reading complete instructions, confirm
all controls on fireplace are in the OFF posi-
tion. Plug the fireplace into a 15AMP/120Volt
outlet. If the cord does not reach, you may
use an extension cord rated for a minimum
of 1875 WATTS. Once the fireplace insert
has been properly connected to a grounded
electrical outlet, it is ready to operate.
OPERATION BY
THE CONTROL PANEL
The controls are located behind the grill
below the front glass and can be accessed
by pulling the grill from the top, forward
and down.
WARNING: DO NOT TOUCH. HOT SURFACE
AT CENTRE OF GRILL. HANDLE LEFT OR
RIGHT SIDE OF GRILL WHEN PULLING OUT.
O/I:
Press this button for main power and
flame effect. The indicator light will turn on.
See below for other control switches.
750W:
For low heat function - Press this
switch while the O/I switch is in the on posi-
tion for low heat. The indicator light will turn
on.
1500W:
For high heat function - Press this
switch while the O/I switch and the 750W
switch are in the on position for high heat.
The indicator light will turn ON.
TEMPERATURE CONTROL:
To adjust the
temperature to your individual requirements,
turn the temperature control dial to the right
(clockwise) to increase the desired tempera-
ture and to the left for lower temperature.
This temperature control dial can only be
used while the O/I switch and 750W &
1500W switches are in the ON position. When
the heater reaches the desired temperature,
the heater and 750W/1500W indicator light
will turn off but the fan will continue to oper-
ate. Adjust this knob to restart the heater.
fig. J
