Qualitel QT6131, Instruction Manual

Page: 12 / 14

12
5. Follow the same procedure to set the hour and minute of end time and press the MENU key to confirm,
the FILTER icon is displayed on the LCD.
Note: During the DND mode the incoming caller identification will be displayed on the LCD but the ringer will
be deactivated.
To cancel DND mode, press and hold the MUTE key for 3 seconds, the FILTER icon will disappear.
ALARM CLOCK SETTINGS

Set the alarm clock
1. In on-hook state, press the ALM key, the LCD displays ALARM 1 OFF .
2. Press the UP or DOWN key to select alarm 1 or alarm 2 or alarm setting 3, press the MENU key to
confirm.
3. Press the UP or DOWN key to select ON , then press the MENU key to confirm.
4. Press the UP or DOWN key to set the alarm hour and press the MENU key to confirm.
5. Press the UP or DOWN key to set the alarm minute and press the MENU key to confirm.
6. Follow the same procedure to set other alarm times.

Control of the alarm clock
When the alarm sounds and you wish to cancel the alarm, press the ALM key. The alarm will only sound
when the set time is reached again.
For a extended snooze time of 9 minutes press the FLASH key when the alarm sounds, the snooze will
repeat every 9 minutes for up to 117 minutes. If no key is pressed when the alarm sounds it will
automatically stop.
MUSIC ON HOLD
A) HANDSET:
1. When using the handset during a conversation, press the HOLD/RING key to put the call on hold and the
other party will then hear music.
2. Press the HOLD/RING key again to cancel hold and continue the conversation over the handset.
3. Or hang up the handset, and enter into Hands-free hold mode.
B) HANDS FREE:
1. During a conversation in Hands-free mode, press the HOLD/RING key to put the call on hold, the other
party will hear music.
2. Pick up the handset, the hold mode is cancelled and normal conversation is continued.
3. Or press the HOLD/RING key again or key to cancel the hold mode and continue with Hands-free
conversation.
SELECT DIALING MODE
In on-hook state, press and hold the * key for 2 seconds, the LCD displays PULSE which means the phone is
now set in pulse dialing mode. Press and hold the * key again for 2 seconds, the LCD now displays TONE
which means the phone is now set in tone dialing.
NOTE: The default setting is TONE as most of the network equipment accepts TONE dialling. For more
information on this setting contact your service provider.