3
4
TIP
WARNING
Make sure that mounting screws are anchored into the center of the studs. The use
of a stud finder is highly recommended.
Installers are responsible to provide hardware for other types of mounting situations.
Installers must verify that the supporting surface will safely support the combined
weight of the equipment and all attached hardware and components.
For concrete or brick
wall mounting, follow
Step 2b.
NOTE
Stud Finder
Mounting to a Wooden Stud Wall
2a
Remove the VESA Plate
1
Using the marking template provided, mark
three holes for drilling on the centerline of the
stud.
Using a power drill and 3/16" drill bit, drill
pilot holes of 3/16" (4.5mm) diameter and at
least 2.5" (65mm) depth at the marked
locations in the previous step.
4
Using an edge-to-edge stud finder, find the
edges of the stud.
1
Using a level, mark the centerline of the stud.
2
3
ø 4.5mm
(ø 3/16")
65mm
65mm
(2.5")
(2.5")
Marking Template
Loosen and remove the VESA plate screws on the VESA plate as shown above.
Lift and remove the VESA plate from the mount.
VESA Plate
VESA Plate Screws