5
6
WARNING
Installers must verify that the supporting surface will safely support the combined
weight of the equipment and all attached hardware and components.
Mounting to a Concrete or a Solid Brick Wall
1b
Hold the wall plate (A) as a template against the wall where you want to install your TV,
mark two holes for drilling.
Using a power drill and a 3/8" masonry drill bit, drill mounting holes of 3/8" (10 mm) diameter
and 2.7" (70 mm) depth at the marked locations in the previous step.
1
2
ø 10mm
70mm
(2.7")
(ø 3/8")
70mm
(2.7")
3 Place plastic anchors (W-B) in each hole. Tap each anchor
flush with the wall using a hammer. Using a socket wrench,
mount the wall plates and fasten them with the provided
lag bolts (W-A) and D6 washers (W-C).
NOTE
Do NOT use power drill and do NOT over tighten
the lag bolts.
[ Table 1b ]
The letter "
X
" stands for the spacing between the wall plates. The letter "
L
" (see
step 2
)
stands
f
or the actual length of wire rope.
x
(see T
able 1b)
W-B
W-A
W-C
TIP
If your TV has a VESA of 400x400mm, mount the wall plates at a spacing of 180-220mm,
and use the wire rope length of 500mm.
A
Wall Plate