QualGear QG-SB-002-BLK Installation Manual Download Page 3

Page: 3 / 4

Installing the Speaker Bracket

Screw the speaker bracket onto the speaker.

Using an edge-to-edge stud finder, find the
edges of the stud.

Using a level, mark the centerline of the stud.

Stud Finder

Mounting to a Wooden Stud Wall

NOTE

For concrete mounting,
see Step 3b.

Using a Phillips screwdriver, mount the wall plate and fasten with the provided screws (W-A).

Wall Plate

ø 2.4mm

(ø 3/32")

Using the marking template, mark two holes for
drilling on the centerline of the stud.

QG-S

B-00

2-BL

SKIP TO STEP 4

NOTE

Do NOT use power drill and do NOT over tighten the lag bolts.

Using a power drill and 3/32" drill bit, drill pilot
holes of 3/32" (2.4mm) diameter and at least
1" (25 mm) depth.

25mm

(1")

Speaker Bracket

Speaker

W-A

W-C

Summary of Contents for QG-SB-002-BLK

Page 1: ...mble the speaker bracket and speaker assembly with the speaker mount by using the knob and flat nut that was previously removed from step 1 Then insert the assembled speaker mount with speaker onto th...

Page 2: ...ent Tighten screws firmly but do not over tighten Over tightening can damage the items greatly reducing their holding power ALL QUALGEAR products are intended for indoor use only and any outdoor use v...

Page 3: ...see Step 3b Using a Phillips screwdriver mount the wall plate and fasten with the provided screws W A Wall Plate 2 4mm 3 32 3 5 Using the marking template mark two holes for drilling on the centerlin...

Page 4: ...holes for drilling 2 Marking Template QG SB 002 BLK 1 Using a power drill and 7 32 masonry drill bit drill pilot holes of 7 32 5 5mm diameter and at least 1 2 30 mm depth Place concrete anchors W B in...