Make sure drilled holes are free of dust
so the anchors will be set properly.
TIP
Mounting to a Wooden Joist or Wooden Stud Ceiling
1a
Mounting to a Concrete Ceiling
1b
For concrete ceiling mounting, follow
step 1b, and for truss, follow step 1c.
NOTE
3
4
Using a straight edge, mark the centerline
of the stud, and the locations of where you
want to mount the ceiling adapter.
Using an edge-to-edge stud finder, find the
edges of the stud.
1
2
SKIP TO STEP 2
Stud Finder
Mark the locations of where you want to
mount your suspended ceiling adapter.
1
Insert and hammer the concrete anchors into
the drilled holes. Loop a wire at the end of the
each anchor and twist around itself a few times
to secure.
3
Using a power drill and a 1/4" masonry drill bit,
drill holes of 1/4" (6.0 mm) diameter and
1.5" (38 mm) depth at the marked locations.
2
SKIP TO STEP 2
drill diameter
ø 6.0mm
(ø 1/4")
drill depth
38mm
(1.5")
Using a power drill and a 5/32" wood drill bit,
drill holes of 5/32" (4mm) diameter, and
2" (51mm) depth at the marked locations.
Install the eye bolts (D) into the drilled holes,
then loop wire (J) into the hole of the eye bolts
and twist several times to secure.
3
4
drill depth
51mm
(2.0")
drill diameter
ø 4.0mm
(ø 5/32")
Eye Bolt (D)
Concrete
Anchor (C)
Mark the drill locations on the center of the studs
for security.