Mounting to a Wooden Joist or Wooden Stud Ceiling
1a
Mounting to a Concrete Ceiling
1b
For concrete ceiling mounting, follow
Step 1b, and for truss, follow Step 1c.
NOTE
3
4
Using a straight edge, mark the centerline
of the stud, and the locations of where you
want to mount the ceiling adapter.
Using an edge-to-edge stud finder, find the
edges of the stud.
1
2
SKIP TO STEP 2
Stud Finder
Mark the locations of where you want to
mount your suspended ceiling adapter.
1
Using a power drill and a 1/4" masonry drill bit,
drill four holes of 1/4" (6.0 mm) diameter and
1.5" (38 mm) depth at the marked locations.
drill diameter
ø 6.0mm
(ø 1/4")
drill depth
38mm
(1.5")
2
SKIP TO STEP 2
Using a power drill and a 5/32" wood drill bit,
drill holes of 5/32" (4mm) diameter, and
2" (51mm) depth at the marked locations.
Install the eye bolts into the drilled holes, then
loop wire (B) into the hole of the eye bolts and
twist several times to secure.
drill diameter
ø 4.0mm
(ø 5/32")
drill depth
51mm
(2.0")
3
4
Mark the drill locations on the center of the studs
for security.
Eye Bolt (D)
3
Insert and hammer the concrete anchors (C)
into the drilled holes. Loop a wire at the end of
each anchor and twist around itself a few
times to secure.
Concrete
Anchor (C)
Make sure drilled holes are free of dust
so the anchors will be set properly.
TIP