5
6
Mounting to a Concrete Wall
1b
Hold the marking template (F) provided against the wall where you want to install your AV
equipment, mark four holes for drilling.
1
F
Marking Template
6
WARNING
Installers must verify that the supporting surface will safely support the combined
weight of the equipment and all attached hardware and components.
NOTE
Do NOT use power drill and do NOT over tighten the lag bolts.
A
Wall Plate
P-A
P-B
QG-DB-002-BLK
Using a power drill and a 5/16" masonry drill bit, drill mounting holes of 5/16" (8 mm) diameter
and 2.2" (55 mm) depth at the marked locations in the previous step.
2
ø 8mm
(ø 5/16")
55mm
(2.2")
(2.2")
55mm
3 Place concrete anchors (P-B) in each hole. Tap each anchor flush with the wall using a hammer.
Using a proper Phillips screwdriver, mount the wall plate (C) and fasten them with the provided
lag bolts (P-A).
