11
10
Customer Helpline
01904 727500
www.gardenservicecentre.co.uk
Customer Helpline
01904 727500
www.gardenservicecentre.co.uk
Operating the Hedge Trimmer
Step 2 - Starting the Engine (continued)
ATTENTION!
Don’t touch the blade.
2b Starting under warm conditions
1) Set the switch (
A
) to 1
(
on).
2) Set the choke lever (
F
) to ( ).
3) Pull the starter grip (
B
) quickly until engine runs.
Pull the handle lock switch (
C
) to enable rotation of the handle. There are 3 working positions
(0°, 90°, -90°).
Step 3 - Change rear handle position
Step 4 - Trimming
Depress the throttle lever lock (
D
) and throttle lever (
E
) to activatee the blade.
Step 1 - Removing the blade protector
Operating the Hedge Trimmer
Remove the blade protector.
Step 2 - Starting the Engine
2a To start a cold engine
1) Set the stop switch (
A
) into the 1
(
on) position. If starting a cold engine the choke lever (
F
)
must be moved to the “ “ position.
2) Press the primer bulb 5~6 times, the fuel can be pumped into the carburettor. This will reduce
the number of start attempts after a longer break.
3) Now stand the hedge trimmer on the ground, place left hand on the front handle. Use your
right hand to pull the starter grip (
B
) quickly.
4) Once the engine attempts to run.Move the choke lever (
F
) to the position.
5) Pull starter handle quickly to start engine. If it could not start, squeeze the throttle interlock and
the throttle trigger 2-3 times. Then pull the starter grip again until the engine runs. Let it run for
about 15 seconds then operate this hedge trimmer.
A
2a&2b
1
2
3
4
5
6
5~6
1
0
1
0
B
C
D
E
Pull
F
