The following table gives checks and actions that you can perform if your machine does not operate cor-
rectly. If these do not identify/remedy the problem contact an Atco-Qualcast Approved Service Agent.
Warning: Switch off, remove plug from mains before investigating fault
.
Clean the exterior of the machine thoroughly using
a soft brush and cloth. Do not use water, solvents or
polishes. Remove all grass and debris, especially
from the ventilation slots
9
.
Turn the machine on its side and clean the blade
area. If grass cuttings are compacted in the blade
area, remove with a wooden or plastic implement.
Store the lawnmower in a dry place. Do not place
other objects on top of the machine. To save
space, fold up the handle fully (Figure
H
).
Ensure cables are not trapped when folding/un-
folding top handles, do not drop the handles.
Atco-Qualcast
P.O. Box 98
Broadwater Park
North Orbital Road
Denham-Uxbridge
GB-Middlesex UB 9 5HJ
✆
Service ..................................... +44 01895 838782
Fax Service ..................................... +44 01895 838789
✆
Advice line .............................. +44 01895 838791
Fax .................................................. +44 01895 838793
Measured values determined according to
2000/14/EC (1.60 m height, 1 m distance away)
and EN 25 349.
Typically the A-weighted noise level of the product
is: sound pressure level 79 dB (A) concorde 32,
81 dB (A) elan 32
;
sound power level: 90 dB (A) con-
corde 32, 92 dB (A) elan 32.
The typical weighted acceleration is 2.5 m/s
2
.
We declare under our sole responsibility that this
product is in conformity with the following stand-
ards or standardization documents: EN
60
335,
EN 836 according to the provisions of the directives
89/336/EEC, 98/37/EC, 2000/14/EC.
2000/14/EC: The guaranteed sound power level
L
Wa
is lower than 93 dB (A) concorde 32, 94 dB (A)
elan 32. Conformity assessment procedure accord-
ing to Annex VI.
Notified body: SRL, Sudbury England
PLACE: Stowmarket, 10/2001
Signature:
Position: Director
Fault Finding
Symptom
Possible Cause
Remedy
Machine fails to operate
Power turned off
Mains socket faulty
Extension cable damaged
Fuse faulty/blown
Turn power on
Use another socket
Inspect cable, replace if damaged
Replace fuse
Machine functions
intermittently
Extension cable damaged
Machines internal wiring damaged
Inspect cable, replace if damaged
Contact Service Agent
Machine labours or belt
seals
Machine not cutting
Height of cut too low
Blades off cut
Increase height of cut
(see “Height of Cut Adjustment”)
Blades require adjustment
(see "Adusting the Blades")
Machine leaves ragged
finish
Blades off cut
Cutting blade(s) blunt
Contact Service Agent
Blades require adjustment
(see "Adusting the Blades")
Cutting blades not rotat-
ing
Cutting blades obstructed
Belt is slipping or is damaged
Clear obstruction
Contact Service Agent
Excessive vibration/noise
Cutting blades damaged
Cutting blades not adjusted evenly
Contact Service Agent
Blades require adjustment
(see "Adusting the Blades")
Poor collection
Mowing in wet conditions
Grass to dry
After Mowing/Storage
Service
Declaration of Conformity
ELAN/Concorde 32 Seite 6 Mittwoch, 25. Februar 2004 8:57 08
