background image

Disclaimer

Quail Digital accepts no liability for injury (in the absence of any negligence or other breach of duty), loss or damage arising from 
use of its products as a result of a failure to use them in accordance with the relevant instructions of use.

Regulatory notices

Headset - HVIN: Q-P11HS

FCC ID: UDDQP10HS   This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause 
undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate 
the equipment. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are 
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio 
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, 
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television 
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the 
following measures: Reorient or relocate the receiving antenna; Increase the separation between the equipment and receiver; Connect the equipment 
into an outlet on a circuit different from that to which the receiver is connected; Consult the dealer or an experienced radio/TV technician for help.

ISED ID: 6402A-QP10HS   

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: 

(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of 
the device.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique 
Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:

L’appareil ne doit pas produire de brouillage; L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en 
compromettre le fonctionnement.

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. Cet équipement est conforme aux limites d’exposition 
de radiation IC énoncés pour un environnement non contrôlé.

Base Station - HVIN: Q-P11BS

FCC ID: UDDQP11BS   This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause 
undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate 
the equipment. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

In order to comply with FCC and IC RF Exposure requirements, the base station must be installed and operated such that a minimum separation distance 
of 20 cm is maintained between the base and all persons during normal operation. 

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are 
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio 
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, 
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television 
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the 
following measures: Reorient or relocate the receiving antenna; Increase the separation between the equipment and receiver; Connect the equipment into 
an outlet on a circuit different from that to which the receiver is connected; Consult the dealer or an experienced radio/TV technician for help.

ISED ID: 6402A-QP11BS   

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) 

this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada 
applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:

L’appareil ne doit pas produire de brouillage; L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre 
le fonctionnement.

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. Cet équipement est conforme aux limites d’exposition de 
radiation IC énoncés pour un environnement non contrôlé.

Summary of Contents for QP10HS









Reviews: