page 8
Step 9 - Setting up the charger
The Q-P10CH charger(s) are likely to be located in
the staff room, manager’s office or other back-
office area always ensuring that the headsets
remain in good range of a base station. The
charger(s) can be wall mounted on a shelf
(Q-P10SHELF).
The charger uses the 5v Q-PSU5 power supply.
The green LED indicates that the charger is
powered on.
Headset LEDs pulse blue every 10 seconds
while charging. The LED turns solid blue when
fully charged. Batteries are fully charged from
discharged in about 4 hours.
Step 10 - Registering headsets
To register the headsets follow this procedure:
•
Make sure all the headsets you wish to register have a charged battery inserted and the LED is
flashing blue. Flashing blue every second indicates that the headset is not registered.
•
One at a time hold each headset just in front of the registration point, the flashing LED on the
headset facing the registration point. The registration point LED will fast-flash green and then turn
solid green for 3 seconds to signify registration of that headset is complete.
•
Give the headset a couple of seconds to settle. You’ll hear a single tone in your ear. Press to talk,
speak, and hear yourself.
•
The headset LED pulses once every 4 seconds when registered and in normal stand-by mode. If the
LED flashes quicker, every second, it means the headset isn’t registered, so repeat the process.
•
Once registered and audio checked place the headset back in the charger for a few minutes to
synchronise with the wider system.
•
Repeat the process until all the headsets are registered.
•
If you are adding headsets to a system that’s already in use, you can run this process even when
people are using other headsets at the time.
