Quadstick FPS, User Manual

Page: 34 / 94

Changing Profiles
The configuration profile mode sheets are numbered starting with 1, in the order their sheets
appear in the spreadsheet window. The default method to increment to the next profile is to
activate the Right Sip tube. Puffing on the Right tube decrements the mode to the previous
profile. The active profile's number is displayed on the status LEDs when the profile changes
and after a short delay whenever no inputs are active. The LEDs are numbered one through
five, left to right. After mode five, the fifth LED stays on and the pattern starts over from the left
until the nineth mode, then both four and five stay on and the pattern repeats. The sum of the
LED numbers indicates the mode number up to 15.
increment_mode normal right_sip
decrement_mode normal right_puff
Since the command to change between modes is controlled within the mode's profile, another
input signal can be used instead of the Right Sip/Puff, if desired. A example would be using the
button that activates a scope or zoom in an FPS to also change to the Right Analog mode for
aiming, regardless of which mode was active before. This example from Far Cry 4 changes the
mode from 1 to 3 and brings up the scope when mp_left_puff is activated.
left_2 toggle mp_left_puff
increment_mode normal mp_left_puff
increment_mode normal mp_left_puff
Voice mode commands can also switch the Quadstick directly to any desired mode.
34