Go to the opposite side of the vehicle and line up
the holes and place the knob in the hole.
NOTE: The oval cutout on the bow bracket must
fit into the oval on the door surround. It should
be flush when installed and there should be very
little if any movement of this bracket once secu-
red with the door surround knobs.
Over Door bow mounted
to first bow bracket
8
the door surround hole. The center bow should
be towards the rear of the vehicle.
Line up one side and place the short door su-
rround knob into the hole securing the center
bow (Do not tighten yet) (FIG38).
expose the bow mount brackets installed on the
first bow.The bow ends on the first bow have a
multi piece bracket welded to the end of the bow
(FIG
39
). This center bow attaches to the ve-
hicle using the door surround knob installed in
step 7 above, located in between the front and
rear door surround (FIG
40
). Remove these door
surround Knobs from each side of the vehicle
and place the center bow bracket hole over
Now tighten each knob securing the bow to the
door surround (FIG41).
FIG42
FIG43
FIG44
the over door bows and slip the knob into the
hole in the first bow mount (FIG
43
) by pulling
the knob out and then releasing. Repeat on the
other side. This will secure the back of the hea-
der assembly to the vehicle (FIG44).
FIG45
FIG46
FIG47
FIG48
Step
8
: Installing the Two Center Bows The
first center bow as circled in FIG
35
has been
permanently installed to the deck assembly.
To install this bow, you will need to place the
soft top on top of the vehicle (Have a
friend help!) with the front header resting on
the windshield and the rest of the soft top
towards the rear of the vehicle (FIG
36
). Now
fold back the Winds-hield header as shown in
FIG
37
which will
Step 9: Installing the Top Deck and Front
Windshield Header Assembly
With the first bow installed to the vehicle and the
front windshield header folded back (FIG42).
Locate the Quick Release knobs on the ends of
