March 26, 2020
7039-804B
23
Figure 23.2
Locknut
Latch Cam
Spacing
Washers
Door Cross
Section
Square Key
Door Handle Shaft
Fiber Handle
Service Part: SRV7033-071
1. Slide door handle through door.
2. Install additional washer(s) as shown in
Figure 23.2
3. Install key in groove.
4.
Align groove in latch cam with key; slide latch cam
over shaft
5. Install locknut but do not over tighten, the handle needs
to rotate smoothly.
6.
Install fiber handle (
Figure 23.2).
Magnet
Spade
Connectors
Snap Disc
Figure 23.1
C. Snap Disc
Service Part: SRV230-0470
1. Locate the snap disc bracket assembly at the bottom left
rear corner of the appliance.
2. A magnet holds the bracket to the appliance. Pull the
bracket down away from the appliance to expose the
snap disc.
3. Pull the snap disc and spade connectors up and out of
bracket as shown in
Figure 23.1
4. Using a Phillips head screw driver, remove the 2 screws
from the snap disc and then remove the snap disc from
the spade connectors. Replace with new snap disc and
re-connect to spade connectors.
5. Push the snap disc and spade connectors back inside
bracket and re-attach the bracket to the appliance.
NOTE:
DO NOT over tighten locking nut; door handle
needs to move smoothly!
D. Door Handle Assembly
