February 25, 2016
7038-207E
19
5700 STEP TOP ACC
A. Glass Replacement
1. Ensure that the
fi
re is out and the appliance is cool to the
touch.
2. Protect a table or counter top with padding or towels.
Protect your hands and wear gloves to prevent injury.
3. Remove the door with the broken glass by lifting the door
up and off of the hinges.
4. Lay door face down on a table or counter making sure the
handle hangs over the edge so the door lays
fl
at, on a soft
surface.
5. Remove the screws from each glass retainer and remove
the glass. (If screws are dif
fi
cult to remove, soak with
penetrating oil
fi
rst).
6. Center the glass with edges evenly overlapping the open-
ing in the door, (i.e. same space top and bottom, left and
right sides).
7. Replace the glass retainers. Be careful not to cross thread
the screws.
8. Tighten each retainer just a few turns until each is
secured. Check again for centering of glass in door
frame. Continue to tighten each retainer alternately, a
few turns at a time, until the glass is secure. DO NOT
OVERTIGHTEN.
9. Replace the door on the appliance.
Quadra-Fire stoves are equipped with ceramic super heat-
resistant glass, which can only be broken by impact or
misuse. Do not slam stove door or impact the glass. When
closing door, make sure that logs do not protrude against the
glass. Inspect glass regularly. If you
fi
nd a crack or break,
immediately put the
fi
re out and return the door to your dealer
for replacement of glass before further use.
WARNING
Injury Risk.
• Use only glass speci
fi
ed in manual.
• DO NOT REPLACE with any other material.
Handle glass assembly with care.
When cleaning glass:
• Avoid striking, scratching or
slamming glass.
• Do NOT clean glass when hot.
• Do NOT use abrasive cleaners.
• Use a hard water deposit glass cleaner on white
fi
lm.
• Use commercial oven cleaner on heavier deposits.
• Remove all residue of oven cleaner or will permanently stain
glass on next
fi
ring.
Refer to maintenance instructions.
Glass
Assembly
CAUTION!
B. Snap Disc Replacement
1. Disconnect power supply. Locate the snap disc bracket
assembly at the bottom left rear corner of the appliance.
Figure 20.1.
2. A magnet holds the bracket to the appliance. Pull the
bracket down away from the appliance to expose the snap
disc.
3. Pull the snap disc and spade connectors up and out of
bracket as shown in
Figure 20.2.
4. Using a Phillips head screw driver, remove the 2 screws
from the snap disc and then remove the snap disc from
the spade connectors. Replace with new snap disc and
re-connect to spade connectors.
5. Push the snap disc and spade connectors back inside
bracket and re-attach the bracket to the appliance.
Snap Disc
Magnet
Spade
Connectors
Figure 20.1
Figure 20.2
Snap Disc Location
5
Service Part Replacement
