Quadra-Fire 31M-ACC-AU, Installation Instructions Manual, Page: 7 / 16

March 4, 2015 7033-308D
Page 7
3100 Series ACC Wood Burner
DESCRIPTION
Pioneer Double Flue Mounted Shield Universal
Shall be Fitted
With Double Flue
Shield Fitted
A Min. Clearance from back of unit to rear wall 175mm
B Min. clearance from center of spigot to rear wall 345mm
C Min. distance from front of base to fl oor protector front 300mm
D Min. fl oor protector front width 800mm
E Min. distance from rear wall to front of fl oor protector 1062mm
F Min. distance from unit side to side wall 325mm
G Min. clearance from center of spigot to side wall 633mm
Quadra- fi re 3100 Step Top ACC does not require a insulating Floor Protector, as they are tested and
comply with the minimum Floor Protector requirements of
AS/NZS 2918:2001.
Note:
▪ The minimum Floor Protector sizes are speci fi ed in the clearance chart, see Table 3 & 4.
▪ A Floor Protector can include ceramic tiles with grouted joints fi xed directly onto a wooden fl oor or
a sheet of toughened glass, panel steel or any other non combustible material laid directly onto a
wooden
fl oor.
▪ If installed directly onto a concrete slab, the concrete slab can be considered as the fl oor
protector,but must maintain the minimum measurement listed.
FLOOR PROTECTOR - 31 Step Top
PARALLEL POSITIONNG - 31 Step Top
NOTE: HEAT SHIELD REQUIREMENTS FOR HEAT SENSITIVE WALLS
Clearances may be reduced by provision of an appropriately located heat shield refer to
AS/NZS 2198:2001 3.2.3 TABLE 3.1
Table 3
Fig. 5
FLOOR PROTECTOR
B
C
D
F
E A
G
REAR WALL
SIDE W
ALL
REAR W
ALL