April 30, 2015
7046-191C
19
27I-ACC
E. Glass Cleaning
• Frequency:
As desired
• By:
Homeowner
• Clean glass with a non-abrasive glass cleaner. Abrasive
cleaners may scratch and cause glass to crack.
• If the deposits on the glass are not very heavy, normal
glass cleaners work well. Heavier deposits may be
removed by using a damp cloth dipped in wood ashes or
by using a commercially available oven cleaner.
• After using an oven cleaner, it is advisable to remove any
residue with a glass cleaner or soap and water. Oven
cleaner left on during the next
fi
ring can permanently stain
the glass and damage the
fi
nish on plated metal surfaces.
• A portion of the combustion air entering the
fi
rebox is de-
fl
ected down over the inside of the door glass.
• This
air
fl
ow “washes” the glass, helping to keep smoke
from adhering to its surface.
• When operated at a low burn rate, less air will be
fl
owing
over the glass and the smoky, relatively cool condition of
a low
fi
re will cause the glass to become coated.
•
Operating the appliance with the Burn Rate Air Control
and Start-Up Air Control all the way open for 15-20 min-
utes should remove the built up coating.
CAUTION! Handle glass assembly with care. Glass is
breakable
.
• Avoid striking, scratching or slamming glass
• Avoid abrasive cleaners
• Do not clean glass while it is hot
F. Inspect Firebrick
• Frequency:
After each ash removal
• By:
Homeowner
Replace the
fi
rebrick if they become crumbly and/or if there
is a 1/4 inch (6.35mm) gap between the bricks.
The
fi
rebox is lined with
fi
rebrick, which has exceptional in-
sulating properties. Do not use a grate; simply build a
fi
re on
the
fi
rebox
fl
oor. Do not operate appliance without
fi
rebrick.
1. After the coals have completely cooled, remove all old
brick and ash from unit and vacuum
fi
rebox.
2. Remove new brick set from box and lay out to the diagram
shown in the instructions that come with the brick set or
refer to the diagram on the service parts list at the end
of this manual.
3. Lay bottom bricks in unit.
4. Install rear bricks on the top of the bottom bricks. Slide
top of bricks under clip on back of
fi
rebox wall and push
bottom of bricks back.
5. Install side bricks. Slide top of brick under clips on side
of
fi
rebox and push the bottom of the brick until it is
fl
ush
with the side of the unit.
