2100-I & 3100-I FIREPLACE INSERT
Page 25
March 1999
FIGURE 3
FIGURE 4
FIGURE 5
FIGURE 6
5. To remove the secondary combus-
tion tubes, slide them to one side until
one end is out of its hole. Then, while
lifting that end of the baffle plate, pull
the tube up over the secondary air chan-
nel and out of the hole at its other end.
See Figure 3
Note:
When replacing the second-
ary tubes on the 3100-I, the tube with
the larger holes is installed in front.
6. To remove the baffle plate, use both
hands to lift it off of the alignment pin
at the center rear. One edge of the bent
baffle front will have a diagonal cut.
Tilt this side up as you slide the baffle
towards that side until the other side
clears its shelf and the baffle can be
lowered.
See Figure 4.
7. Keep the baffle tilted as you lift it
out the door.
See Figure 5.
8. To install the baffle, reverse Steps 1
through 7. The hole in the baffle must
be on its alignment pin on the rear shelf.
See Figure 6.
PIN
TUBES
ALIGNMENT
PIN
BAFFLE:
REMOV
AL &
RE-INST
ALLA
TION
