Vendetta Quick Start Guide
To begin, please follow the unboxing and setup video that we have created here:
https://youtu.be/ludf3F76Rng
To connect your receiver, follow the instructions in the video. The receiver wire is
colored white, red, and black. White is signal, red is 5V power, and Black is ground.
Connect this servo lead to your receiver- The receiver plug on the powercube that is
inside of the Vendetta can handle PPM, SBUS or SPEKTRUM inputs, and this is
selectable via the OSD menu.
More information about the powercube can be found here:
http://www.team-blacksheep.com/tbs-powercube-manual.pdf
This is the same powercube that is installed in the Vendetta and the powercube
manual should help to explain some more about how the Vendetta works.
We recommend calibrating your Vendetta by following the On Screen display prompts
when
fi
rst powering on, after you have bound and installed your receiver.
If you are an advanced user and setup your model in Clean
fl
ight, then you can skip the
OSD prompts before
fl
ight by following the Existing setup instructions below.
RC Calibration
You can find more about the Core Pro OSD here:
http://www.team-blacksheep.com/tbs-core-pro-manual.pdf
It is recommended that you read this manual in addition to following the quick
start guide for a complete overview of the hardware that is installed on the
Vendetta.
R/C Calibration is required to teach the TBS CORE PRO and the Flight controller inside
the Vendetta which stick performs which action on your remote control. R/C
Calibration comes up either automatically if you are running the CORE PRO for the
fi
rst
time, or it is available in the R/C menu under “Flight Controller”
→
“Calibration”
→
“RC
Calibration”.
Page of
2
5
©2016 QuadQuestions LLC.
