Owner's Manual
QUADLITE XTREME ARCH RAMPS
Page 2
Check for parts online at
www.quadboss.com
or call 877-847-1558
WARNING
READ, UNDERSTAND AND FOLLOW ALL ASSEMBLY,
INSPECTION, & USE INSTRUCTIONS PROVIDED
BEFORE EACH USE. FAILURE TO FOLLOW ALL INSTRUCTIONS,
WARNINGS & LOAD CAPACITY RATING COULD RESULT IN
SERIOUS INJURY OR DEATH.
IF ANY INSTRUCTIONS ARE NOT UNDERSTOOD OR IF YOU HAVE
A PARTS ISSUE CALL 877-847-1558 BEFORE USING.
DO NOT USE AN ATV ON THIS RAMP IF THE ATV HAS SNOW
CHAINS ON TIRES. CHAINS WILL CAUSE DAMAGE TO YOUR
RAMP AND IS HAZARDOUS!
BE CAREFUL OF PINCH POINTS AT RAMP TAB LOCATIONS WHILE
SECURING RAMP TO TAILGATE.
THIS RAMP IS FOR USE WITH 4-WHEELED ATV’S OR UTV'S ONLY.
DO NOT USE WITH 2- OR 3-WHEELED VEHICLES OR VEHICLES
EXCEEDING 2,500 LBS.
SAFETY STRAPS MUST BE SECURELY HOOKED UP TO VEHICLE TO
PREVENT RAMPS FROM SLIDING OFF TAILGATE. TEST BEFORE
USING OR YOU COULD BE SERIOUSLY INJURED. BE SURE YOUR
TRUCK IS IN PARK AND EMERGENCY BRAKE ENGAGED.
BE SURE 4-WHEELED ATV OR UTV IS CENTERED ON RAMPS. DO
NOT USE WITH ANY VEHICLE THAT HAS WIDER TIRES THAN THE
RAMP WIDTH.
MAXIMUM USABLE HEIGHT, GROUND TO LOADING POSITION, IS
NO MORE THAN ONE HALF THE LENGTH OF THE RAMP.
BE SURE RAMP IS PROPERLY PLACED AND SECURED AS
DESCRIBED IN LOADING INSTRUCTIONS.
QUADBOSS offers a full line of ATV/UTV accessories. We appreciate
your purchase of one of our world class Ramps. Follow these few
simple instructions and your product will be sure to give you many
years of trouble free pleasure. Instructions should be kept in a safe
place and reviewed at least annually.
If for any reason you have a problem with your product,
DO NOT
return to the retailer
; contact the QUADBOSS customer service
department at 877-847-1558 or [email protected] for
assistance.
ASSEMBLY INSTRUCTIONS:
1. Attach the two provided securing straps to the center brace,
approximately 16" from the tailgate end (one on each ramp). Wrap
the loop end of each strap around the center brace and thread
the buckle and “S” hook end thru the loop. This permanently
attaches straps to the ramp.
SEE FIGURE 1
.
USE INSTRUCTIONS:
TO LOAD YOUR 4-WHEELED ATV OR UTV
1. On level ground, rest ramps on tailgate.
SEE FIGURE 2.
Be
sure ramps are centered on tailgate and aligned correctly to your
4-wheeled ATV or UTV’s wheel width.
2. Hook the “S” hooks of both straps to bumper and pull on loose end
of straps until straps are tightly holding ramp to tailgate. Be sure
ramps have not moved location when tightening straps. Double
check to make sure ramps are still aligned correctly. To remove,
simply push the thumb release on strap buckle.
3. Using an electric or manual winch, draw the ATV or UTV up the
ramps.
DO NOT drive the ATV or UTV up the ramps.
4. Once vehicle is in truck bed, be sure to set brake & securely tie
down vehicle. Ramp can now be removed, folded up, and stored.
1. Reverse loading procedures to unload your ATV or UTV.
TO UNLOAD YOUR 4-WHEELED ATV OR UTV
S
s-hook
loop
bumper
tailgate
FIGURE 1
FIGURE 2
straps tight
