154.018UK User Manual
Placement
The ZP18 has a built-in
dual “U” bracket, which can allow the can to be free standing or fixed to trussing.
If free standing, ensure that the ZP18 is positioned on a stable, non-slip surface.
If mounted at height onto a truss or stand, it is advised to use a drop wire for additional safety.
Allow adequate space for access to the controls and to avoid straining cables and connections.
Rear Panel
1.
DMX out XLRF connector
2.
LED digit display
3.
Control panel
4.
Mains inlet wire (terminates to IEC male)
5.
DMX in XLRM connector
6.
Mains fuse 5 x 20mm F3A 250V
Setting Up
The ZP18 has a hard-wired lead with an in-line IEC plug for mains power connection (4)
Connect to a mains outlet using the supplied IEC mains lead, ensuring that the voltage and current capacity
are correct for powering the ZP18.
The ZP18 can operate as a stand-alone item from internal programs or from DMX512 signal.
Standalone modes are shown below.
Mode
Details
STAT
Static colour with strobe and zoom options
AUTO
AT01-AT10
Built-in auto preset sequences
PR01-PR10
Stored user programmable sequences
SOUd
2 sound-activated modes
RUN
DMX enables control from a DMX512 signal
SLAV sets the fixture to mimic a standalone ZP18 connected to the DMX input
The setup of the fixture is accessed via the onboard menu as shown on the next page.
