178.192UK User Manual
Setting up
Remove the tripod stands from the carry bag and extend each tripod base so that the legs are
sufficiently spaced to support each speaker on a stable and even surface. Extend the upper telescopic
section to the required height.
Open the SC100
“
suitcase
”
by unfastening the clips at either side of the handle and lifting the centre
console lid. With the lid opened fully, it is possible to lift out each of the 2 speakers, which should be
fitted to the top of the tripod stands.
Unzip the bag adjacent to the mixer-amp console and remove all accessories.
Connections
Connect the mixer-amp to both speakers using the included speaker jack leads (33, 34)
If required, connect the included microphone to channel 1 or 2 (22, 24) using the supplied XLR lead.
XLR sockets on channels 1 & 2 are for microphones, whereas the jack sockets (23, 25) are for mono
line inputs. Use either mic or line input, not both together into a single channel.
(Line input can be CD player, computer sound card, sub mixer etc.)
Channel 3 has a jack input (25) for mic or instrument (guitar, keyboard etc.) and another jack (26) for
line input.
Channel 4/5 is a stereo channel with 2 RCA sockets (27) for left and right line inputs.
If the stereo mix of all inputs is to be fed onto additional PA or recording equipment, there is a stereo
line output via RCA sockets (28) which should be linked to stereo line inputs of the external equipment.
There is also a mono line output (ideal for a wedge monitor) via a jack socket (29)
Finally, for monitoring the mix through headphones, there is a stereo phones jack output (30)
When all signal connections are completed, connect the IEC inlet (31) to a suitable mains supply using
the included power lead.
Initial settings
•
Set all faders (5, 7, 9, 20) to the zero mark (fully down)
•
Set all tone controls (6, 8, 10, 12) to the 12 o
’
clock position (vertical)
•
Set all Graphic EQ faders (14) to the zero mark (mid position)
•
Turn channel 4/5 rotary controls (4) to the zero mark (fully down)
•
Turn the EFFECTS and PHONES rotary controls to zero mark (fully down)
The SC100 PA is now ready to be switched on