154.037UK User Manual
Installation
The PL-COB6Q is supplied with a mounting bracket which can be used as a free-standing support or hanging bracket.
When installing the fixture, ensure all fixings are secure, controls and connections are accessible and do not obstruct the
rear cooling fan vents.
Operation
Static colour
To select one of the preset static colours, press Menu until the display shows
xx
or
xx (where “
**
” is a number)
.
Press the up/down buttons until
to
is displayed
and press enter to select one of these options.
Auto programs
To select auto colour change or scroll, press Menu until the display shows
**
or
**
(where “
**
” is a number)
.
Press the up/down buttons until
or
is displayed
and press enter to select. Pressing Menu again until the
display shows
-
enters the speed adjustment for the program, which can be set using the Up/Down buttons.
Strobe setting
In either static colour or auto program mode, pressing Menu until
** is displayed
(where “
**
” is a number
) enters
strobe mode.
is no strobe, whereas
-
strobe speeds can be set using the Up/Down buttons.
The strobe effect will flash in the colour(s) of the auto program.
Sound-to-light
To select the sound-to-light function, press Menu until the display shows
xx
or
xx
(where “xx” is a number)
, press the
up/down buttons until
or
is displayed
and press enter to select.
is a sound activated colour change and
is a sound activated strobe effect.
Master/slave mode
To use in Master/Slave mode, connect PL-COB6Q units with XLR cables from DMX out to DMX in as a daisy chain.
On the Master unit (first in the daisy chain), using the 4 control buttons on the back panel, select your chosen program.
All subsequent units in the daisy chain should be set to DMX address
to set them up as Slave units. These will then
mimic the output of the Master unit.
DMX mode
To control the fixture via a DMX controller, simply connect the DMX signal source (controller) to the
‘
DMX in
’ of the unit
using a balanced XLR lead. Additional fixtures can be controlled by the same DMX signal by connecting an XLR cable from
DMX out of the first unit to DMX in of the second unit, DMX out from the second unit to DMX in of the third unit and so
on... For long daisy chains, it is advised to use a DMX terminator plug on DMX out of the last fixture. Press the Up/Down
buttons to set the DMX start address
-
