Changing the diffuser:
The QTX Pixel-Bar comes supplied with 2 diffusers, white and clear. Replacing one with the other is a very
simple procedure. Firstly remove the 4 screws from one end of the unit and remove the end cap. Next
slide the diffuser out and carefully replace with the alternative one. Finally replace the end cap and screws
ensuring it
’
s in alignment before tightening.
Specifications:
Power supply
110-240Vac, 50/60Hz (IEC)
Power consumption
60W
Fuse rating
F3A
LED type
SMD 5050 RGB
LED quantity
224
Modes
Static colour, colour change, colour fade, auto, sound active,
DMX, master/slave
DMX channels
3, 5, 8, 24, 48, 53
Dimensions
1100 x 60 x 60mm
Weight
1.35kg
Troubleshooting:
No power (mains)
Check mains voltage is correct and outlet is switched on
Check IEC lead and fuse (if fuse continually blows, refer to your dealer)
No light output
Check control panel mode settings
Check DMX settings from controller (dimmer levels, blackout etc.)
Unresponsive to DMX
Check that unit is in DMX mode and ensure the A on the DMX address flashes
to confirm it
’
s receiving a DMX signal
Check DMX controller is not set to black out
Check DMX controller is on correct fixture/page
Check master dimmer value
Check correct DMX address is set
Check DMX connection and leads
Overheating/
cutting out
Ensure adequate ventilation and unit is not too close to a heat source
This product is classed as Electrical or Electronic equipment and should not be disposed with other household or commercial waste
at the end of its useful life. The goods must be disposed of according to your local council guidelines
.
Errors and omissions excepted.
Copyright© 2022 AVSL Group Ltd, Unit 2 Bridgewater Park, AVSL (Europe) Ltd, Unit 3D North Point House,
Taylor Road, Trafford Park, Manchester. M41 7JQ.
North Point Bus. Park, New Mallow Road, Cork, Ireland.
