Rear Panel:
1.
Fluid level indicator
2.
IEC power input
3.
Earth screw (do not remove)
4.
Power switch
5.
Remote control input
Operation:
Wired Control Unit:
1.
The wired control unit supplied with the MoonCloud-400 must be connected at all times during
use.
2.
Once the unit is warm enough to produce fog, the red LED at the bottom of the unit will light up.
3.
For simple fog on demand press and hold the red button on the panel, release to stop the fog
supply.
Please note:
The unit
’
s default LED setting is sound to light which will be enabled unless the RF
remote is used to control the specific LED unit functions.
RF Remote Control:
The small RF remote supplied can be used to control both fog supply and the LED functions of the unit.
Please note:
the receiver for the RF remote is located within the wired control unit so this must be
connected for it to function correctly. See below for details of functions using the RF remote:
1
: Continuous fog start/stop
2
: Auto LED Mode slow/fast
3
: LED sound to light mode (default)
4
: LED individual modes select