178.960UK 178.961UK User Manual
Bluetooth
®
Connection
On the media player, select
‘
’
using the
MODE
button.
Scan for Bluetooth devices on your smart phone or other Bluetooth enabled audio player and
check for a device called
“
PAL series
”
. Select this device and opt to connect your Bluetooth
device, which should then state that it is connected to
“
PAL series
”
for audio output.
Play audio from your Bluetooth device and check for output through the PAL unit.
Ensure that the volume is turned up on the smart phone or other sending device.
If there is no output, check if there is more than one device within range called
“
PAL series
”
In the eventuality that more than one device is called
“
PAL series
”
, try each device in turn until
the PAL unit is found. Check also that the volume level is turned up on the sending device.
Once audio is playing through the PAL from Bluetooth, adjust the MASTER control (12) to the
required volume.
In Bluetooth mode, the
,
,
buttons can also remotely control playback from the
sending device.
TWS (True Wireless Stereo) pairing
The Bluetooth receiver in the PAL is capable of pairing with another PAL unit, so that it plays
just one side of the stereo audio and relays the other side of the audio to the other PAL over
Bluetooth. This sets up a pair of PAL units as a wireless stereo set, known as True Wireless
Stereo pairing.
To activate this function, pair a smart phone to one of the pair of PAL units and press and hold
the button labelled
TWS
for 3 seconds on each PAL unit until an audio prompt confirms the
TWS pairing. Bluetooth playback from the smart phone will now be reproduced by both PAL
units with one playing the left channel and the other playing the right channel.
Holding the
TWS
button on either unit for 3 seconds will cancel the TWS function.
Front LED light effects
You may decide to activate the LED light show on your PAL unit by pressing and holding the
button labelled
“
LED SWITCH
”
for 3 seconds. These LEDs will sequentially switch colours, which
increases in speed when there is sound coming from the speaker. Pressing the
“
LED SWITCH
”
button for 3 seconds again will deactivate the LED light show.
Talkover function
To override music playback when speaking into the microphone, press and hold the button
marked
TALKOVER
for 3 seconds. When active, this will automatically reduce the music output
volume whenever you speak into the microphone and resume the music volume when the
microphone is silent. Holding TALKOVER again for 3 seconds will deactivate this function.