User Manual –WDMX-1
154.150UK
6
8. Operating:
You first need to ensure you have two devices minimum in order to begin.
Each unit can be set as either a transmitter or receiver and can be easily
changed by “switch 4” (see diagram). You then need to set both the
transmitter and receiver addresses the same for it to work.
8. Installing:
Plug in a 3 pin XLR DMX lighting cable in to the DMX INPUT on the transmitter
device. Ensure that you are connecting in line of a current DMX connection or
directly to a controller. To begin transmitting
Plug in a 3 pin XLR DMX Lighting cable in to the DMX OUTPUT on the receiver
device. Ensure that the receiver is within 100m of the transmitter in line of
sight and is connected to a fixture ready to receive a DMX signal.
Note:
You can use up to 80 receives in different locations with the same
address
User Manual –WDMX-1
154.150UK
3
2.
Package contents :
Please check the contents to ensure that the product has been received in
good condition.
WDMX-1 x 1 unit
User’s Guide x 1pcs
1 x Power supply and cable
If you find any accessory is missing or the unit has arrived with any problems,
please contact your local dealer at once. This product contains no user
serviceable parts so make no attempt to try to fix or modify this item yourself
as you may invalidate the warranty. We recommend you keep the original
package and proof of purchase for any possible replacement or returned
demand.
3.
Caution :
For your safety, please kindly pay attention to all of the warnings below:
Always plug in the power plug last and disconnect from the mains, when
the device is not in use or before cleaning.
Do not operate the device in rain or extreme heat, moisture or dusty
environments.
This device is for indoor use only and in a dry environment.
Do not switch on immediately but wait until it reaches room
temperature, if the device has been exposed to drastic temperature
fluctuations.
Do not shake the device and avoid excessive force when installing or
operating