Qtone DA-1001, User Manual

Page: 11 / 20

User Guide - DA-1001
11
Advanced Setup
Changing Input Name
By default the amplifier will have the input selections named based on the input number or
location. These can be changed to any 14 character name. Press and hold the input that the name
is to be changed on. The display will then show a flashing cursor on the first letter of the input
name. Turn the Multi-Control knob to change the letter, use the left and right arrows to move to
another character, the Clr button to clear the currently selected letter and the Ent button to
finish entering and confirm the name. This will return you to the main volume display.
1:#NPUT 1
IP GAIN [#e----]
Press and hold
required input
Setting Input Source Pre-Amp
The amplifier has the ability to boost individual inputs regardless of the current volume settings.
This allows for each input to be set to provide a consistent overall volume depending on a device.
For example: if one source is louder than the others then it can be reduced so that you wouldn’t
need to adjust the master volume just for that input.
To change the pre-amp level, enter into the name change mode and then press the Multi-Control
knob and turn it to adjust the gain up or down.
Turn Multi-
Control
1:JNPUT 1
IP GAIN [#e----]
Press > button
1:J#PUT 1
IP GAIN [#e----]
Press < button
1:#NPUT 1
IP GAIN [#e----]
Press Clr
button
1: NPUT 1
IP GAIN [ĉĉĉ---]
Press Ent
button
1: NPUT 1
VOL [##--------]
1: NPUT 1
IP GAIN [#e----]
1: NPUT 1
IP GAIN [#e----]
Press Multi-
Control
1: NPUT 1
IP GAIN [##r---]
Turn Multi-
Control
1: NPUT 1
IP GAIN [#q----]
Turn Multi-
Control