Sampling is the process of “teaching” your scale to calculate a unit weight or “weight per 1000”
pieces. Once the scale knows the unit weight, it can quickly provide a count by dividing the
weight on the scale by the unit weight.
This is the most critical step in the entire counting process. The golden rule of sampling is this:
the larger the initial sample size, the more accurate your counts will be. There is a breakeven
point, however, at which point an increased sample size will provide little or no additional
accuracy. We suggest you use the sampling sizes listed in the table below as a starting point.
You may then experiment with these values to find a reasonable tradeoff between the time
spent sampling and the resulting accuracy.
Turn the scale on by pressing the ON/ZERO key. Press the UNITS key to cycle through grams,
lbs, oz, and PCS - select ‘PCS’. Next press the NET/GROSS key to cycle through the available
samples sizes: C10, C20, C50, C100, and C200. Select a sample size of 10, 20, 50, 100, or 200
pieces, and place that exact amount of items on the scale.
Next press the UNITS key - ‘CAL’ will appear and then the scale will display the selected
sample size in the window.
Select from the following sampling procedures depending on the item you wish to count:
FUNCTION:
How to Sample
2
Sheet Size
Sampling Procedure
8-1/2 x 11”
Press the NET/GROSS key to cycle through the
available samples sizes and select:
C20
5-1/2 x 8-1/2”
Press the NET/GROSS key to cycle through the
available samples sizes and select:
C50
2 x 3-1/2” or Smaller Sheets
Press the NET/GROSS key to cycle through the
available samples sizes and select:
C100
NOTE:
If you will be counting fewer than 1000 sheets you may use a smaller than
specified sampling size.
PAPER SAMPLING:
Item Type
Sampling Procedure
Small, light weight items, such
as beads, screws, etc.
Press the NET/GROSS key to cycle through the
available samples sizes and select:
C50
Medium weight items, such as
fittings, extrusions, etc.
Press the NET/GROSS key to cycle through the
available samples sizes and select:
C20
Larger items, such as heavier
castings, finished products, etc.
Press the NET/GROSS key to cycle through the
available samples sizes and select:
C10
PARTS SAMPLING:
