Beyond Navigation
BT-Q1000eX eXtreme Recorder
™
..............................................................................................................................................................................
……….…..……………………………………………………………………………………………………………………......................
www.Qstarz.com
8
Log
(Red)
Flash per 2 sec: Low
memory (20%)
Flash 3 times:
POI(Point of Interest)
is recorded
Memory is
full
Log Mode
is off
Beeper Code
Status
Beep code
Description
Startup
1 short beep
One short beep on off->1Hz,
Off->5Hz, 1Hz->5Hz, or 5Hz->1Hz
GPS fix
2 short beeps
2 short beeps when GPS fix on 1Hz
or 5Hz mode
POI button
3 short beeps
3 short beeps when POI button
being pressed
Memory
exhausted
3 long beeps
3 long beeps when the device is out
of memory
Sleep mode
1 long and 1
short beeps
1 long and then 1 short beep when
the device enters sleep mode
*Beeper can be turned off from software -> Config GPS.
5-5. Function of Vibration Sensor
Vibration Sensor
: Vibration Sensor is functioned for power saving
and waypoint saving. It will detect the physical movement of the
device. When it detects the device not moving more than 10 minutes,
Q1000eX will enter sleep mode so that the Blue LED will turn to flash
every 5 seconds. Under sleep mode the log will be disabled.
When the device is on sleep mode, SHAKE the device to wake it up
and the blue LED will turn to flash every 2 seconds (at 5Hz mode this
blue LED will not flash) and GPS Orange LED will be also on.