Revision C—6 December 2019
© 2019 QSC, LLC. All rights reserved. QSC, and the QSC logo are registered
trademarks in the U.S. Patent and Trademark Office and other countries. #44 V.6
qsc.com
QSC Business Music Solutions
Technical Notes
QSC MP-M Series Mixers
Establishing connection with the updated
mixer
Even after a firmware update, the MP-M Series
mixer will retain its prior network settings. If you
are unsure of the mixer’s network settings, please
see the QSC MP-M Series Mixers technical note,
Network setup and troubleshooting
. Use following
instructions if the mixer still has its factory default
network settings.
1. Connect the Ethernet port on the mixer to the
network interface on the PC.
2. Set the IP address of the PC’s network interface
card (NIC) to accommodate a Link Local
connection.
3. Open
MP-M Install
(version 1.1 or higher).
See Figure 3.
4. The software has not connected with an MP-M mixer, so a warning in red appears in the the
lower right corner of the window. Click
Resolve
to find discoverable MP-M mixers.
5. If there are any MP-M mixers on the network, they will appear in a list (Figure 4). Click
MPM-xxxx
(where xxxx is a random number that the MP-M mixer assigns to itself).
6. Log in with the password (Figure 5).
— Figure 3 —
— Figure 4 —
— Figure 5 —
