4
TD-001558-01-B
Connections
Normal Connection
Refer to Figure 2
The LF-2215 has barrier strip screw terminals for connection. The terminals accept up to
#10 AWG (5.3 mm
2
) stranded loudspeaker wiring. Use the largest wire size and shortest wire
length possible for the application. Observe the polarity markings and keep polarity consistent
throughout the system for best performance.
— Figure 2 —
Amplifier capable of
driving 4 ohm loads
Parallel Connection of Second LF-2215
Refer to Figure 3
The terminals labeled OUTPUT may be used to connect another LF-2215 in parallel.
Connect the wires as shown in the illustration, at right. Note: If the LF-2215’s internal wiring
has been modified in any way, this may not function. If this is the case, remove the terminal
cup and verify the presence of the factory yellow jumper and blue jumper wires; correct as
required or have the loudspeaker serviced.
— Figure 3 —
Amplifier capable of
driving 2 ohm loads
Individual Transducer Connection (requires modification)
Refer to Figure 4.
The transducers are wired in parallel inside the enclosure. If individual transducer connection
is required, remove the terminal cup and remove the yellow and the blue jumper wires that are
connected between the INPUT and OUTPUT terminals. Replace the terminal cup and mark the
enclosure with a note of the modification.
WAONN GE:
Requires removal of terminal cup and removing both the yellow
and the blue jumper wires that connect the INPUT and OUTPUT terminals.
— Figure 4 —