8
TD-000477-01-A
4.
F OI TOT
– the Q-SYS Designer firmware version installed on the amplifier.
APRT!:
The DPA-Q 8-channel amplifiers require Version 6.1 or later of Q-SYS Designer.
To Update the Amplifier Firmware:
a. Install the version of Q-SYS Designer you want to use on your PC.
b. The amplifier must be connected to Q-LAN and turned on.
c. Open the Q-SYS design containing the amplifier in the Designer version you just installed.
d. Select "Save to Core and Run" from the File menu.
e. The amplifier and any other Q-SYS peripherals in the design are automatically updated.
LAN A / LAN B Screen
1.
M TDDOTSS
– a default address is assigned in the factory. You can
change this and the other parameters in Q-SYS Configurator. LAN A is
required, and cannot be turned off.
2.
ATRITSK
– must be the same as the Core's Netmask.
3.
NTRT TY
– must be the same as the Core's Gateway.
4. LAN B is not required. When connected, the same type of information
as LAN A is displayed.
Health Screen
1.
FTA OMI
– varies depending on the temperature.
2.
MSA RTIM
– varies depending on operating conditions. PSU Temp is
monitored and can automatically put the amp into limiting or shutdown
if safe operating temperatures are exceeded.
3.
T VPLRTNT
– AC Mains voltage
4.
T AOOTAR
– current drawn on the AC Mains, by the amplifier.
5. Voltage Rails
•
V OT L 1
= +147VDC +/- 5V typical
•
V OT L 2
= -147VDC +/- 5V typical
— Figure 19 —
LAN B (AUTO, NO LINK)
GATEWAY:
NETMASK:
255.255.0.0
IP ADDRESS:
192.168.xxx.xxx
GATEWAY:
NETMASK:
IP ADDRESS:
LAN A (AUTO)
1
2
3
4
— Figure 20 —
HEALTH
FAN RPM:
1109
PSU TEMP:
35.3°C
AC VOLTAGE:
115V
AC CURRENT:
1.61A
V RAIL 1:
145V
V RAIL 2:
-149V
1
3
5
2
4
