8
TD-000264-00-E
Specifications
AD-C81Tw
Frequency Response
1
:
50- 200 kHz (-3 dB), 25- 200 Hz (-10 dB)
Maximum Output
2
:
112 dB SPL continuous RMS output
Calculated 118 dB SPL peak output
Transducers:
LF: 203 mm (8”), 19 mm (0.75”) voice coil;
Nominal Coverage:
180° conical (average 2.5 kHz - 10 kHz)
Impedance (ohms):
8.0 nom./ 8.3 min. @ 42 Hz.
Power Rating
3
:
RMS (IEC 100 hours): 100 W RMS (100 W)
Recommended amp power: 200 watts RMS, maximum
Sensitivity:
92.0 dB, 1 W, 1 meter, flush mounted (2 pi)
Bass Loading:
Ported, tuned to 42 Hz
Optional Processing:
125 Hz. low-pass >12 dB/octave crossover.
Dimensions:
See — Figure 7
Net Weight:
AD-C81Tw: 9.1 kg (20.0 lb.)
Enclosure:
Corrosion-resistant power coated steel enclosure with injection-molded plastic baffle. Press on metal grille
Mounting System:
Captive, integral mounting clamps. Insert enclosure into cutout, and tighten. Suspended ceiling C-ring and support bars included.
Connectors:
Ceramic block connector inputs and terminal block “through” connectors (rated for 400 W max).
Controls:
Transformer “tap” selector/ bypass (8 ohm) switch,
Settings: 7.5, 15, 30, 60 W (15, 30, 60 W for 100 V) and 8 ohms.
Averaged over 50 Hz - 20 kHz bandwidth (60 W tap).
Transformer Distortion less than .01% THD above 100 Hz, 0.2% @ 50 Hz
(30 W tap). Bandwidth: 40 - 20 kHz (-1 dB, all taps).
Agency Listings:
CE, UL 1480 (commercial/professional use, outdoor damp), UL 2043 (air handling spaces).
Specification Notes:
Specifications are subject to change without notice.
1 All frequency ranges specified refer to measured half-space response (2 pi).
2 Calculated maximum peak SPL at 1 m, half-space, speaker operating at rated rms power pink noise input, 50 Hz to 20 kHz.
3 Maximum input power tested in accordance with IEC recommendations; 50 Hz to 20 kHz band limiting, 6 dB signal crest factor.
