21
3.2.
Upgrade Memory
CAUTION:
The following instructions should only be performed by an authorized
and trained technician. Strictly adhere to the instructions to install a
RAM module on the NAS.
Before you start, please ensure that you turn off the NAS, disconnect
the power adapter, network cable(s), and also remove any other
device/cable that is attached to the NAS.
XN7024R is installed with two 4GB ECC DDR4 memory module by default. If you want to
install, check, or remove a memory module on your XCubeNAS, please follow the steps as
illustrated below:
1.
Shutdown your XCubeNAS and disconnect power, network cable(s) or any other
device/cable that is attached to your system to prevent any possible damages.
2.
Remove the controller from the system chassis.
Loosen the screws below the release lever on the back of the XCubeNAS.
Pull down both release lever at the same time, then pull out the controller.
Use one hand to hold one end of the controller module (the side with release levers)
and the other hand hold the bottom of the controller. Pull out the controller module
until it is free from the system chassis.
CAUTION:
The controller module is very heavy, please use both hands while
installing, removing, or carrying the controller module. Recommended
place for removing the controller module: the system is in a well secured
rack or on a stable surface.
