20
©
Copyright 2019 QSAN Technology, Inc. All Rights Reserved.
3.2.
Upgrade Memory
CAUTION:
The following instructions should only be performed by an authorized
and trained technician. Strictly adhere to the instructions to install a
RAM module on the NAS.
Before you start, please ensure that you turn off the NAS, disconnect
the power adapter, network cable(s), and also remove any other
device/cable that is attached to the NAS.
XN5008RE is installed with two 4GB DDR4 memory module by default. If you want to install,
check, or remove a memory module on your XCubeNAS, please follow the steps as
illustrated below:
1.
Shutdown your XCubeNAS and disconnect power adapter, network cable(s) or any other
device/cable that is attached to your system to prevent any possible damages.
2.
Remove the rear top cover.
Loosen the screw on the back of the XCubeNAS.
Pull the rear top cover, and put it aside.
CAUTION:
When you remove the rear top cover, the sensitive internal components
are exposed. Please avoid touching anything other than the memory
module when you add or remove a memory module.
