Installing the System Hardware
33
3.6.
Connecting Power Cords and Powering ON the System
Before you power on your XCubeDAS system for the first time, please make sure following
tasks are done:
Check the power cord type. The power cords for the XCubeDAS series will vary
depending on your country/region. If you find the power cords included with your
XCubeDAS system doesn’t match your current country/region, you may need to buy an
adapter for each power cord to connect the power outlet.
Power cord ratings:
。
100 – 127V~ 10A
。
200 – 240 V~ 5A
Install all disk drives in the system so the controllers can identify and configure them at
power-up.
Connect cables that connect the management port and data ports to your network, and
then power cords to the system; finally press the power button once to power on the
XCube SAN.
Figure 3-17
Press the Power Button One Time to Power on the System
INFORMATION:
The power cord rating is the minimum requirement. The rating of the
power cord that you purchase must equal to or higher than the minimum
requirement to ensure the system safety and reliability.
Summary of Contents for XCubeDAS XD5324D
Page 83: ...Support and Other Resources 69...