SideKar / SideKar Plus User Manual rev 3.2 Page 14 of 84
KX2 Installation
The SideKar sits on the top back of the KX2.
1. On the KX2, remove the Elecraft swinging foot and set it
aside for later installation on the SideKar™.
Install 2
supplied thumbscrews into the holes in the back of the
KX2, as shown.
2. If not already installed, install 2 supplied thumbscrews
in the bottom 2 holes in the SideKar. (lower right of the
On-Off switch, and lower left of the Rig port.) Install the
2 KX2 brackets under the thumbscrews as shown.
Note that the brackets are not symmetrical. The longer
side goes on the SideKar. The shorter side will be on
the KX2.
Install the swinging foot on one of the SideKar™
brackets, then tighten the thumbscrews.
KX2 Foot removed
Thumbscrews Installed
