QRPKits KD1JV, Instruction Manual, Page: 7 / 22

Assembly Instructions:
The quickest and easiest way to build the rig is in “layers”. The lowest profile parts are installed first, such as resistors and
diodes, then higher profile parts such as capacitors and so on. Once the board is populated with all the parts, testing will
be done by inserting the various Integrated Circuit chips one at a time and testing the associated stages they are used
with.
Before you start assembly, it is helpful to sort the parts into types and values. Using a number of paper or plastic picnic
bowls to sort the parts into is a good idea to keep parts from getting lost on the bench. If you loose, damage or are
missing a part, send a message to parts@qrpkits.com for a replacement. Please specify the part type and value. For
example, instead of saying you need R22, say you need a 1K resistor. Otherwise, we will have to look up the parts list for
the kit and figure out what R22 is and that can delay getting you that part.
In general, parts are numbered on the board in rows, starting with the lowest part number in the upper left corner of the
board (this is the back end), and then run left to right and then zig-zag down the board to the front end. Parts will be
inserted in that order. Part values are labeled on the parts placement diagram for easy reference. There are two placement
diagrams included. The first is in color, which makes the various parts types stand out better, but would use a lot of ink to
print out. A second, ink jet friendly diagram is also included. At least one of these diagrams should be printed out for easy
reference as you build up the board. Note that the band specific parts have no value labeled. See band table for values
later in manual.
7