LEGAL
QOLSYS CONFIDENTIAL AND PROPRIETARY PAGE 32 OF 32
© Last updated 6/3/15 All rights reserved
LEGAL (Cont.)
•
Do not short circuit the battery by connecting the positive terminal to the negative terminal.
High currents can be generated resulting in high
temperatures and risking fire and personal injury
M. FALSE ALARM WARNINGS
The following warnings cover the likely potential situations that may cause False Alarms Reports (FAR) to be generated.
Cause of FAR:
User fails to enter proper pass code or enters the wrong pass code while trying to disarm system.
Prevention:
Carefully enter your passcode.
Remember your passcode and/or write it down in a safe place that is easily accessible.
Cause of FAR:
User fails to exit premise before exit delay timer expires while trying to arm system in Away Mode.
Prevention:
Listen to exit beeps and last 10 second voice countdown … if running out of time, then either press the Extend button to extend the exit delay or
press cancel … and then start the rearming process again once you are ready to leave the premises.
Cause of FAR:
User opens a door, but fails to close the door before the exit delay timer expires while trying to arm system in Away Mode, thus causing an exit
fault and alarm condition.
Prevention:
Be careful to close the door tightly upon exit during the arming process.
If an exit fault / alarm does occur, then quickly reenter the home and
disarm the alarm.
Cause of FAR:
Erroneous fire detection alarm from sensor.
Prevention:
During installation, system can be set to require two fire sensor detections prior to generating central monitoring station fire alarm … note a local fire
alarm will still sound to alert the homeowner.
Cause of FAR:
Erroneous Carbon Monoxide detection alarm from sensor.
Prevention:
During installation, system can be set to require two Carbon Monoxide sensor detections prior to generating central monitoring station gas leak
alarm … note a local fire alarm will still sound to alert the homeowner.
Cause of FAR:
Erroneous user fire, auxiliary or police panic alarm generated.
Prevention:
Do not press the Emergency button unless there is a real emergency.
If the emergency alarm is accidentally activated, then quickly enter the disarm
pass code which will then cancel the alarm.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This Class [B] digital apparatus meets all requirements of the Canadian Interference
-
Causing Equipment Regulations.
Cet appareil numérique de la classe [B] respecte toutes les exigences du Réglement sur le matériel brouilleur du Canada.
IMPORTANT!
Changes or modifications not expressly approved by Qolsys Inc. could void the user’s authority to operate the equipment.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause
interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the
device
CAUTION!
This equipment complies with radiation exposure limits set forth for uncontrolled environment. The antenna(s) used for this transmitters must be installed to
provide a separation distance of at least 20 cm from all persons and must not be collocated or operating in conjunction with any other antenna or transmitter.
Cet appareil est conforme avec Industrie Canada RSS exemptes de licence standard (s). Son fonctionnement est soumis aux deux conditions suivantes: (1) ce
dispositif ne doit pas causer d'interférences, et (2) cet appareil doit accepter toute interférence, y compris celles pouvant causer un mauvais fonctionnement de
l'appareil
ATTENTION! Cet équipement est conforme aux limites d'exposition aux rayonnements définies pour environnement non contrôlé. L'antenne (s) utilisé pour cette
émetteurs doit être installé pour fournir une distance de séparation d'au moins 20 cm de toute personne et ne doit pas être installé à proximité ou utilisé en
conjonction avec une autre antenne ou émetteur.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.