48
Chapter 7.
Install and Hot-swap Hard Drives
7.1
Install Hard Drives
Follow the below steps to install hard drives on the NAS.
TS-112P, TS-212P and TS-251C
1.
Turn off the NAS. Disconnect the power adaptor, network cable (s), and any other
connectors or cables from the NAS.
2.
Before installing the hard disk drives, put on an antistatic wrist strap to prevent
electrostatic discharge. The crocodile clip should be connected to the ground.
3.
Loosen the screws on the rear (top and bottom) of the NAS. Remove the case cover
of the NAS by sliding it apart (see the underside of the NAS for visual indicators of
the NAS case being locked/unlocked.)
