6
magicolor
6100 Print System
Remove the left side cover
from the printer.
Connect the duplex unit
cable to the black
connector at the left rear
side of the printer.
Reattach the left side cover.
! !0$+ 1"
Refer to the
Connecting
Your QMS Print System
manual
for instructions on
how to connect your printer
to a computer or network.
» Note:
The printer requires a brief warmup
(typically 3 minutes).
Plug the printer into a
grounded, surge-protected
electrical outlet.
»
Note:
In compliance
with UL guidelines, “The
appliance inlet is
considered to be the
main disconnect
device.”
A startup page should
print when the printer is
turned on.
2 0
See the
Connecting Your
QMS Print System
manual
for instructions on installing
the QMS printer driver.
Use the on line help to
configure the driver for
printing.
See the
magicolor
6100
Operation
manual
for
further instructions on
advanced printer
configuration through the
control panel menus.
(
Internet—Visit the QMS Product Registration page on the Internet
at http://www.qms.com/support/prodreg/.
Mail—Fill out and send in the warranty card enclosed in your
shipment.
Refer to one of the following:
•
magicolor
6100
Operation
manual.
• Appendix A, “QMS Customer Support,” in any
magicolor
System manual.
#$$ 34
QMS,
magicolor
, and the QMS logo are registered trademarks of QMS, Inc. Adobe, Acrobat, the Acrobat logo/Adobe Systems Incorporated.This docu ment
is Copyrighted © 2000 by QMS, Inc., One Magnum Pass, Mobile, AL 36618. All Rights Reserved. This document may not be copied in whole or in part, nor trans-
ferred to any other media or language, without the express written permission of QMS, Inc.
5
6
1
2
1
2
Installation
Operator
Administration
Idle
Operator
Use Operator
Admin
Use Admin
Off, On
(Enter
Off, On
Control
password)
password)
(Enter
