QMS 2425, Operation Manual

Page: 27 / 186

/RDGLQJWKH
0XOWLSXUSRVH
7UD\
&RQVXPDEOHV
5HPRYLQJWKH)DFHXS7UD\
Use the following instructions to remove the face-up tray:
1 Remove first the right tab, and then the left tab on the face-
Up tray from the slot on the back of the printer.
» Note: Remember to disable the Operator Control/Outputbin/Face
up setting.
2WKHU0HGLD'HOLYHU\2SWLRQV
The QMS Stackler Option, which includes three large-capacity output
trays, provides face-up, face-down, job offset, and stapling media
delivery options. See chapter 8, “Document Finishing Options,” in the
Options manual for more information.
/RDGLQJWKH0XOWLSXUSRVH7UD\
Use the multipurpose tray to print on envelopes, labels, odd-size
media, and transparencies. The multipurpose tray is also especially
useful if you want to print on a single sheet of letterhead or colored
media without changing the media in the media cassettes. Its capac-
ity is approximately 100 sheets of 20 lbs (75 g/m
2)
cut-sheet media .
When the tray is not in use, retract it into the printer
.
This section explains how to load print media in the multipurpose tray.
For tips on how to get the best possible printing results, see “Enve-
lopes: Special Considerations,” “Labels: Special Considerations,” and
“Transparencies: Special Considerations,” at the end of this section.