QMS 2425, Operation Manual

Page: 130 / 186

&RQWURO3DQHO
3UREOHPV
406785%23ULQW6\VWHP2SHUDWLRQ
2 Turn the printer off. From a cold start, the printer takes
approximately 1 to 2 minutes to warm up.
Be sure you wait long enough for a start-up page before suspect-
ing a problem.
3 Check to be sure the paper cassettes are loaded with paper,
in place and secure.
4 Open the top cover of the printer and check for a media jam.
5 Make sure a toner cartridge is installed.
If you still have not solved the problem, you need to call your QMS
vendor for help. Go to the last section of this chapter, “Placing a Ser-
vice Call.”
3DSHU-DP0HVVDJH6WD\V2Q
If a
PAPER JAM
message stays on, open the printer and clear the
jam. If the message is still there, try opening and closing the top of the
printer again.
See “Media Jams” on page 6-18
in this chapter for more
information.
3ULQWHU5HVHWV
Occasionally, Macintosh applications interfere with each other. Appli-
cations send a printer prep file to the printer at the beginning of each
document. Other prep files cannot be sent without resetting the
printer. Monitor your activities to see if there is a correlation between
your use of a certain application and the printer resetting. If so, con-
tact the application developer.
Downloading too many typefaces can overload the printer memory
and cause the printer to reset to default. Additional memory (RAM),
which can be used for font storage, is available and easily installed.
Contact your QMS vendor for information on RAM upgrades. See
chapter 2, “Memory and Systems Software,” in your
Options guide.
If the printer resets in other circumstances, you should call your QMS
vendor for service.