Contemporary Research
6
QMOD-HDMI1.5
Common
This series of menus sets global values for QMOD operation
Channel
Sets the physical channel, 2-135
QAM
Selects QAM 64 or QAM 256 (default). Fixed at 256 when 2-channel mode is enabled.
Continuous Wave is often used to test the channel with a meter.
256 | 64 | CW
Cable format
Standard cable frequencies (default)
HRC – same as Standard, channels 5 and 6 slightly different
IRC – All channel frequencies are different than the standard cable setting
RF Level
Sets the RF level of the channel.
29 | 25 | 21 | 17 | 13 | 9
IP Mode
Selects Static (default) or DHCP IP modes
DHCP will select new address, will switch to static if network not present
IP Address will show change when you select DHCP
If you go back to Static, the address you defined in that mode will be set
IP Address
192.168.1.231
Left/Right steps through each group, click Up or Down arrow to step one at a time, hold
down to move faster. Address also appears on LCD when QMOD restarts.
Gateway
255.255.255.000
Quad address – Left/Right steps through each group, click Up or Down arrow to step one
at a time, hold down to move faster.
Subnet Mask
255.255.255.0
Subnet has a limited range of combinations, so this function is simplified
Left/Right steps through each group, click Up or Down arrow for options
Telnet Port
2728 (default)
IP port for Telnet communication – Click or hold Up or Down to set.
Output Stream
Select outputs for stream, IP menus only appear when selected.
RF |IP|RF+IP
QMOD IP Port
Enter IP address for IPTV
UDP Mode
Selects UDP mode, sub menus change depending on mode
Unicast|Multicast
DstMultiAddr
Enter IP address for multicast
Dest IP Addr
Enter destination IP address for unicast
Dest IP Port
Enter UDP port for unicast or multicast
MAC/SN
Shows network MAC address
Ex: 00:04:9F:14:30:40 (last 2 bytes is the serial number)
LCD Contrast
Contrast 1-15
LCD Bright
Display brightness 1-16
Temperature
Internal temperature
Fan Speed
Set fan speed in percent
Backlight
Display brightness 1-10
CVCT
Activates inclusion of virtual channel ID and short Name in the video stream.
On (default) | Off
FW version
Firmware version
